ITT Cannon Male Dust Cap, Shell Size 16 IP67 Rated, Polymer
Τεχνικό φυλλάδιο
Προδιαγραφές
Λεπτομέρειες Προϊόντος
Dust Caps
Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.
Neptune
Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.
Ημερομηνία αποθέματος προσωρινά μη διαθέσιμη
Παρακαλούμε ελέγξτε ξανά αργότερα.
€ 8,27
Μονάδας (Σε μία Σακούλα των 100) (Exc. Vat)Χωρίς Φ.Π.Α
€ 10,255
Μονάδας (Σε μία Σακούλα των 100) (Including VAT) Με Φ.Π.Α
100
€ 8,27
Μονάδας (Σε μία Σακούλα των 100) (Exc. Vat)Χωρίς Φ.Π.Α
€ 10,255
Μονάδας (Σε μία Σακούλα των 100) (Including VAT) Με Φ.Π.Α
100
Τεχνικό φυλλάδιο
Προδιαγραφές
Λεπτομέρειες Προϊόντος
Dust Caps
Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.
Neptune
Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.